Custom Removable Pull-Up Bar E3

Note on custom length

The custom length must be specified after deducting 3 mm. A deduction of 3 mm from the measured distance is strictly required to ensure the pull-up bar fits perfectly between the walls.

Calculation example: Measured distance 1300 mm - 3 mm to ensure fit = custom length 1297 mm.

The distance must be measured directly at the desired mounting location, as the distance between walls can vary significantly depending on the exact measuring point.

The distance between the walls should be measured using two folding rules or a laser distance meter. A laser distance meter also makes it very easy to align the drill holes on the opposite wall.

The tube is simply inserted into the U-shaped wall brackets from above. Since each wall bracket is 8 mm thick, applying the 3 mm deduction means the tube rests on the wall plates for a length of 13 mm (6.5 mm on each side).

It should be noted that both tube ends are closed with plastic blanking plugs. These plastic plugs are slightly convex, providing a slight tensioning of the tube and thus preventing it from rotating too easily. Otherwise, the tube is not secured against rotation. This means the tube could rotate around its own axis during excessive swinging or careless use and, in the worst-case scenario, jump out of the brackets.

If the rotation of the tube is absolutely undesirable, the removable pull-up bar E4 or the fully welded pull-up bar E2 are highly recommended.

More detailed information, further descriptions, and graphical representations of the pull-up bar E3 can be found in the blog.